Electronic devices used for creating signals with transmission frequencies are done with the assistance of radio frequency generators, also known as RF generators. The way in which AM radios were created is originally the reason for the term “radio frequency.” Signal frequencies produced when we talk, also known by the term “audio frequencies,” tend to not go very far. Range was expanded by placing the audio frequencies of voice or music on top of a radio wave, which could be transmitted many miles. A radio frequency of 100 kilohertz can be accomplished by AM transmitters.

RF, or radio frequency, even when not equipment that is a radio, still indicates the transmission frequency. RF frequencies may be found in everyday items such as cell phones, which measure at is estimated at 900 megahertz, and the standard GPS is approximately 1.5 gigahertz. RF generators are needed in order to convert the audio frequency for each of these transmission mediums.

Signal is multiplied further up to the transmission frequency, which generates a low frequency of 44 kilohertz for broadcasting a digital signal from a satellite. By combining digital and transmission signals together, which were generated by the RF generator, you’re producing a modulated signal, which is then transmitted to the satellite. Any satellite home receiver works going the other way using this same concept. Signal generators will boost the broadcast received and convert it to a 44 kilohertz baseband frequency.

Requiring a substantial amount of power to reach the satellite, the RF generator can be utilized in broadcasting work. This equates to a generator that is large, costly, and requires a lot of power. Conversely, your satellite receiver uses a much lower-power generator, which is in turn, more affordable and smaller. In fact, for any system, whether it be satellite radio, cell phones, or FM radio, there are always a lot more receivers manufactured than transmitters. This generally requires that receiver manufacturers design their components fully to the the board level. Using modular components costs too much for these units which must be priced at their absolute least expensive to be able to compete in the market.

Fabrication of archetype units, which have the identical form and functionality as the end product, are produced by competing businesses often. Having the potential for being really expensive and taking up a lot of time, even a slight modification is highly challenging with this type of tactic. And changes are always required, regardless if the prototypes are very similar to earlier manufactured products. A better method is to start with a prototype unit constructed with off-the-shelf components. For example, if you are planning to try it, you’ll find it much easier to buy an all-purpose generator versus spending time developing your own RF generator.

This needs to be accomplished at the same time as the in-house generator layout, or it can be done as an initial measure in order to eliminate serious flaws associated with earlier designs. This will enable you to try out different alternative design paths right away. Instead of having the first look take two years, a prototype unit can be put together for managers and investors in only ninety days.